SCC AK-001 Carrera GT3 / Modern Sports Car Rear Axle Kit. This kit is designed to replace the entire rear axle assembly (except tires) on many modern 1:32 Carrera GT3 and modern sports cars (see partial list below). This rear axle assembly is also a perfect replacement for the 1:32 Carrera Nascar NextGen ZL1 Camaro. Of particular note are the oversize wheels (18.5 x 9.4mm) in the kit that match the oversize Carrera stock plastic wheels. The oversize wheels allow aftermarket tires (see recommendations below) to match the stock tire OD while maintaining the low profile sidewall appearance. Kits with smaller 17mm wheels CANNOT achieve this!
This kit is intended for racers who:
- Need to replace broken stock plastic rear wheels and/or crown gear.
- Want higher quality components (e.g. CNC machined wheels) and tighter tolerances (e.g. solid axles, bronze bushings) than the stock parts.
- Want the flexibility of changing gear ratios.
- Want to improve car performance while increasing longevity.
The kit consists of high-quality aftermarket components including:
- 2x (1 pair) - CB Design 18.5mm x 9.4mm Insert Wheels
- 2x (1 pair) - CG Slotcars Modern GT / DTM Wheel Inserts
- 1x - 54mm Solid Axle
- 2x (1 pair) - SCC Bronze Bushings
- 1x - Slot.It 27T Crown Gear (brass hub)
- 1x - Slot.It 9T Inline pinion (see "Tools Required" section)
- 3x - M2 x 3mm set screws
Note: The retail value of these parts if purchased individually is over $30.00
Examples of Cars This Kit Is Designed For (Not All-Inclusive)
- Aston Martin GT3
- Audi A4 (DTM)
- Audi R8 LMS
- Audi RS 5 (DTM)
- BMW M4 (DTM)
- BMW M4 GT3
- BMW M6 GT3
- BMW Z4 GT3
- Corvette C6R
- Corvette C7R
- Corvette C8R
- DTM (All 1:32)
- Ferrari 296 GT3
- Ferrari 458 GT2 / GT3
- Ferrari 488 GT3
- Ferrari 575
- Formula E
- Lamborghini Huracan
- McLaren 720S
- Mercedes AMG (DTM)
- Mercedes AMG GT3
- Mercedes SLR McLaren GT
- Mercedes SLS AMG GT3
- NASCAR NextGen ZL1 Camaro
- Porsche 911/997 GT3 RSR
- And more...
Recommended Tires
Quick Slicks (Silicone) - CA02, CA03
Paul Gage (Urethane) - 20115LMXD, 20125LMXD
Tools Required
- 0.9mm Hex Driver (for set screws)
- Pinion puller / press (to install / remove pinion on motor shaft)